Rockler T-Slotwall Cutter Bit

Overall cutting height 13/16".
Works best with MDF and soft woods.
With 1-1/16" diameter, 13/16" height, 1/2" shank.
When working with hardwood, this bit requires a much lower rate of feed to eliminate burning and breakage.

A fantastic value on high quality router bits. These bits are competitively priced while offering high performance and long life.

Quality performance features include:

K10 and K20 grade carbide for clean cutting action.
Final sharpening with 600 - 800 grit diamond wheels.
Precision balanced for smooth operation.
Baked-on anti-stick coating to reduce pitch and resin buildup.

Get a great deal on these superior bits!
Buy 3 or more and get 10% off, or buy 6 or more and get 15% off.

If you are not 100% satisfied with these bits, send them back for a refund.

Router Safety Tips:
It's easy to prevent mishaps if you take a few simple precautions.

1) Rockler recommends using 1/2" shank router bits whenever possible. 1/2" shanks provide better stability with less vibration to produce a smoother cut and longer cutter life.
2) Make multiple light passes rather than one heavy cut.
3) Install your router bit so that 90% of the shank is inside the collet. Here's a rule of thumb: fully insert the bit, then pull it back 1/16 to 1/8 of an inch.
4) Use a router table whenever possible.
5) When using large diameter bits, reduce the RPM of your router. Then test your set-up on scrap lumber.
6) Always follow your router manufacturer's recommendations.