Tambour Router Bit Set

Tambour will look great from both sides and have an interlocking design to keep slats in line and inhibit warping. Works for double or single curve applications. Requires 1/16" coated cable for connecting. Instructions included.

If you are not 100% satisfied with these bits, send them back for a refund.

Router Safety Tips:
It's easy to prevent mishaps if you take a few simple precautions.

1) Rockler recommends using 1/2" shank router bits whenever possible. 1/2" shanks provide better stability with less vibration to produce a smoother cut and longer cutter life.
2) Make multiple light passes rather than one heavy cut.
3) Install your router bit so that 90% of the shank is inside the collet. Here's a rule of thumb: fully insert the bit, then pull it back 1/16 to 1/8 of an inch.
4) Use a router table whenever possible.
5) When using large diameter bits, reduce the RPM of your router. Then test your set-up on scrap lumber.
6) Always follow your router manufacturer's recommendations.