Rabbeting Bit Set

Made with K10 and K20 grade carbide for clean cutting action and final sharpened with 400 grit diamond wheels for longer cutting life. Available in 1/4" or 1/2" shanks. Both with 1/2" cutting depth. Includes bit and bearing soft 5/16", 3/8", 7/16" and 1/2" rabbets for variable cutting depth. Allen wrench included.
Optional Router Bit Sets Available...
4-Piece Straight Bit Set	Biscuit Cutter Set	Round Over Bit Set

If you are not 100% satisfied with these bits, send them back for a refund.

Router Safety Tips:
It's easy to prevent mishaps if you take a few simple precautions.

1) Rockler recommends using 1/2" shank router bits whenever possible. 1/2" shanks provide better stability with less vibration to produce a smoother cut and longer cutter life.
2) Make multiple light passes rather than one heavy cut.
3) Install your router bit so that 90% of the shank is inside the collet. Here's a rule of thumb: fully insert the bit, then pull it back 1/16 to 1/8 of an inch.
4) Use a router table whenever possible.
5) When using large diameter bits, reduce the RPM of your router. Then test your set-up on scrap lumber.
6) Always follow your router manufacturer's recommendations.