Rockler Cove Raised Panel Bit

Rockler Cove Raised Panel Bit Dimensions
	Produces cove profile fielding on door panels for stile and rail construction.

Rockler#	A	B	C	D	Bearing
39456	3-1/2"	5/8"	1/2"	2"	1/2"

A fantastic value on high quality router bits. These bits are competitively priced while offering high performance and long life.

Quality performance features include:

K10 and K20 grade carbide for clean cutting action.
Final sharpening with 600 - 800 grit diamond wheels.
Precision balanced for smooth operation.
Baked-on anti-stick coating to reduce pitch and resin buildup.

These larger bits are designed to be used in a router table.

Router Safety Tips:
It's easy to prevent mishaps if you take a few simple precautions.

1) Rockler recommends using 1/2" shank router bits whenever possible. 1/2" shanks provide better stability with less vibration to produce a smoother cut and longer cutter life.
2) Make multiple light passes rather than one heavy cut.
3) Install your router bit so that 90% of the shank is inside the collet. Here's a rule of thumb: fully insert the bit, then pull it back 1/16 to 1/8 of an inch.
4) Use a router table whenever possible.
5) When using large diameter bits, reduce the RPM of your router. Then test your set-up on scrap lumber.
6) Always follow your router manufacturer's recommendations.

Caution - Raised Panel Bit Safety Tip:
3-1/2” diameter bits are not recommended for use with steel or aluminum router plates with 3-5/8” maximum openings, including the Rockler large aluminum router plates.