893PK Router with FREE Porter-Cable Micro-Adjust Edge Guide! Limited Time Only!

Router Features:

2-1/4 HP, 12 amp soft-start motor
Soft-starting, Variable speed from 10,000-24,000 RPM with advanced electronic feedback to maintain constant cutter speed under load
Low noise vibration
Above-table bit height adjustment, motor release, collet and bit access, and spindle lock for single wrench bit changes
Dual switch locations ensure access from handle gripping, palm gripping and router table mounted positions while preventing accidental start-up when the spindle lock is engaged.
Large opening, see-through sub-base with quick-change release for tool-less changeover between router bases and router tables
Multi-function carrying case with bit and accessory storage. Detaches into a pedestal to place the router between cuts.
Ergonomicaly correct handles with soft, rubberized grip are located close to work surface for maximum control.

Thumb Rotating Turret
Four-position stop rotates to desired depth setting while maintaining a firm grip on the handles. Reduces time and set-up by allowing for pre-set depth changes while the motor is operational.

Dust Sealed Switch
Dust-sealed switch extends above router top in the ON position for easy OFF access. Top switch is easily accessible during single hand gripping operation.

Motor Catch
Special rack design prevents motor from disengaging from the base during micro-height adjustments in a router table. Secondary, Macro-Release lever allows for motor removal.

Micro-Adjustable Stop
Tool-free rotating stop adjusts in small 1/32 inch increments for precise micro-depth adjustments. One full turn = 1/8 inch.

Adjustable Depth Scale
Pre-set plunge depth by lowering the router bit to the work surface and locking. Lower stop rod to the surface of the micro-adjustable stop on the base. Adjust scale marker to zero depth setting. Raise stop rod until the scale marker reads the desired depth setting. Lock stop rod and the router will now plunge to the desired setting.

OPTIONAL ACCESSORIES :

GripVac D-Handle Base GripVac Handle
For single hand gripping operation. Features a soft over-mold surface that molds to the operators hand for maximum comfort and control. This grip method is often preferred when using the router on dovetail machines with repetitive front-to-back movements.

For maximum dust control and additional hand gripping versatililty, the standard base handle is replaceable with the GripVac handle (#26820). The GripVac attachment mounts over the dust access hole.

The GripVac attachment minimizes vacumn hose interference by efficiently exhausting the dust through the top of the handle. Must be used with the clear dust insert included with the base. Dust insert mounts inside the base by removing the sub-base and attraching between the base casting and plastic sub-base.

Micro-height adjustment knob
Fits all 890 series routers and the 8529 router.

Rotate counterclockwise to raise the bit height (One full turn = 1/8 inch) Rotate clockwise to lower the bit.